Laney IRT60H Iron Heart 60w Head หัวแอมป์กีตาร์

The XLR-DI out allows you to connect your amplifier to a PA system or recording interface, without the need for micing. It is fully balanced and features a level switch for -30dB (PA/Desk level) or +4dB (Line level) for driving powered cabinets directly. The XLR-DI out also features a ground lift switch is also provided for lowest noise performance. Unlike most other XLR-DI out, the Laney fitted XLR-DI out is post the output section of the amp.

The Vari-Watts control the signal level within the power amplifier, allowing it to be driven harder at lower volume levels. For full output power, running the power tubes at maximum levels, turn this control fully clockwise. To reduce output volume, turn this control to the left.

On-board studio quality reverb. Reverb gives you a sense of the space that you are in. A dry guitar signal can sound a little dull. Adding the right about of reverb provides the guitar signal with ambience and brings it to life.

Pulling on each of the EQ control knobs will shift the response of each control as follows: Bass: Deep – This extends the low-end frequency response, resulting in a fuller, heavier sound for lower notes. Mid: Shift – This lowers the frequency range of the mid control to give a tighter sound. Treble: Shift – This broadens the Treble control frequency response, to give a rounder sound to higher notes, especially when used with thin sounding pickups.

• Switchable cabinet emulation
• FS4-IRT included
• FX loop series/switchable level
• Premium Hand selected ECC83 & 6L6 tubes
• Pre-Boost function
• Push Pull EQ pots
• Modern High gain sounds
• 60 Watts
• Extension speaker socket: 1 x 16 Ohm, 1 x 8 Ohm, 2 x 16 Ohms, 1 x 4 Ohms & 2 x 8 Ohms
• Dynamics control
• 3 channels + switchable boost
• Item dimensions: 271mm x 678mm x 288mm (HWD)
• Item weight: 16.50kg

• การจำลองตู้สลับได้
• รวม FS4-IRT
• FX loop/ระดับที่สลับได้
• หลอด ECC83 & 6L6 คัดสรรด้วยมือระดับพรีเมียม
• ฟังก์ชั่นพรีบูสต์
• Push Pull EQ พอต
• เสียง Gain สมัยใหม่
• 60 วัตต์
• ช่องเสียบลำโพงขยาย: 1 x 16 โอห์ม, 1 x 8 โอห์ม, 2 x 16 โอห์ม, 1 x 4 โอห์ม & 2 x 8 โอห์ม
• การควบคุมไดนามิกส์
• 3 แชนเนล + บูสต์สลับได้
• ขนาด: 271 มม. x 678 มม. x 288 มม.
• น้ำหนัก : 16.50 กก.