AMT Electronics M-Drive

Drive Series effects are designed to be connected in front of a “clean” channel inputs of guitar combos or amplifiers, and do not have a cabinet simulated output as the Legend Amp Series. These pedals allow guitarists to obtain warm, crisp, natural tube sounds of their favorite high gain amplifiers, while preserving individuality and tone of the instrument and equipment.

In the Drive Series, AMT uses new original circuitry solutions developed by AMT specialists based on real actual tube stage emulation and response. The result is bright, rich, full, and powerful distortion sounds.

The AMT M-DRIVE was designed for guitarists looking for distoriton sounds similar to that of Marshall JCM800* amplifier.

• The pedal sensitivity and drive/distortion amount is determined by the position of GAIN control.
• The overall output level is determined by the position of LEVEL control. It’s range of adjustment provides the standard minimum level of -10dB and reaches +8 dB at it’s maximum position.
• The pedal also features a simplified TONE control, which is designed for general tone matching of the pedal to your amplifier. Further EQ adjustment may be made on the expanded preamp section of your amplifer.
• A VOICE switch to cut some mids.
• Standard 9vDC (-) negative center power required. Voltage consumption is low, running at only (less than 4mA) of power.
• TRUE BYPASS circuitry. No tone coloration, signal degregation, or loss while pedals is not in use.

AMT M-DRIVE ถูกดีไซด์มาเป็นเสียง ดิสตอร์ชั่น ซึ่งรู่นนี้ถูกออกแบบมาจำลองเสียงของแอมป์ Marshall JCM800*

• ปุ่ม GAIN คอนโทรลแบบเซนซิทีฟ
• ปุ่มโทนดีไซด์ย่านเลียงมาให้แมทกับแอมป์หลากหลายประเภท.
• ปุ่ม VOICE ออกแบบมาเพื่อตัดย่านเสียงกลาง
• ใช้ไฟแบบ สเตนดาร์ด 9V DC
• เป็นวงจรแบบทรูบายพาส